| ANGLE PLATE | |
 |
The pieces measure 60 x 22 x 120 mm and 40 x 20 x 120 mm. Initially I planned on using cast iron for this project, but it was not as flat as I wanted, so I chose mild steel instead. |
 |
Marking out on surface block with scriber. See Articles #6 and #32. |
 |
The workpiece accurately positioned and clamped on the milling table. |
 |
Four holes are drilled and counter-bored. The workpiece is positioned so that the emerging drill bit will not damage the mill table. |
 |
Slotting with an end mill using a generous flow of cutting fluid. |
 |
The surface of the lower side machined to assure an accurate right angle. |
 |
Cutting the side end. |
 |